KOYO bearing disassembly should pay attention to:

Assembly site should be kept clean, no dust.

To avoid KOYO bearing dust, contaminants and moisture - pollutants have an adverse impact on the operation and service life of the KOYO bearings.

Check the mating surfaces of the bearing bore and shaft: geometric and dimensional accuracy and cleanliness.

Painted with a little oil or a little grease to the mating surfaces of the bearing rings.

5 Make sure the shaft and the bearing hole with a 10 degrees -15 degrees boot chamfer.

Do not over-cooled bearings: condensing moisture can lead to the mating surfaces of the bearing and corrosion.

After installation: to bearings filled with lubricant, check whether the bearing arrangement is operating normally.

Removing the Guide:

KOYO bearings installed parts of the original design should take into account the demolition - If the bearing selection interference fit, the shaft or the bearing hole should be set demolition ferrule with a groove to facilitate removal. Dismantled bearings also reuse:

1. Should avoid directly against bearing rings,

Dismounting force should not be passed through the body to

KOYO bearing dismantled should be carefully cleaned and can not be used "violent" flame.